Automatically monitor water levels and control your motor — preventing overflow, dry runs and unnecessary water wastage. Hard-wired sensor probes keep every reading accurate, even in basements and metal tanks.
Stainless steel probes wired straight to the panel start your pump when the overhead tank runs low and stop it the moment it is full.
Every reading travels over a dedicated cable, so it stays accurate in basements, plant rooms and metal tanks where radio signals struggle.
Automatically monitors water levels and controls the pump to maintain the tank level.
Tank Level Low — Pump Starting
Engineered for accurate sensing, safe switching and years of trouble-free operation.
Starts the pump at the low-level probe and stops it at the full-level probe, keeping the tank topped up without any manual intervention.
Sump and bore-well probes cut power the instant the source runs empty, protecting the motor winding from burnout.
The tank-full probe shuts the pump off immediately, so not a single litre is lost to overflow.
Built-in high and low voltage sensing isolates the motor during unstable supply and restores it automatically once the line is healthy.
Front-panel LED indicators show supply, tank level, pump state and fault conditions at a glance.
An auto / manual selector lets you run the pump on demand for tank cleaning, testing or maintenance.
Estimate your potential savings with our water level controller.
How we estimate
Estimates based on typical pump use. Actual savings depend on your pump and site.
Our engineers handle the whole fit-out, usually inside a single visit.
Suitable for homes, apartments, commercial buildings, farms and more.
Interested in selling the Xpert AutomatiX wired water level controller? Tell us about your business and the area you cover, and our team will connect with you.
A few of the sites our engineers have commissioned.
Indicative ratings. Final configuration is confirmed against your pump and site conditions.
Answers to the questions we hear most about the wired water level controller.
Still have questions?
Our team can help you choose the right controller for your tank and motor.
Contact UsStainless steel sensor probes in the tank are wired straight to the controller. It starts your pump when the tank runs low and stops it the moment the tank is full, so nobody has to switch the motor by hand.
It switches motors up to 1.5 HP directly. Higher ratings are handled through a contactor.
The probes connect over shielded multi-core cable of up to 100 m, so the controller can sit in the pump room while the probes stay in the tank.
Yes. It protects against dry running, tank overflow, high and low supply voltage, and short circuit.
Yes. An auto / manual selector lets you run the pump on demand, for example during tank cleaning, testing or maintenance.
The wired controller suits sites where a sensor cable is easy to run, and places such as basements, plant rooms and metal tanks where radio signals struggle. Where running a cable to the tank is impractical, the wireless controller is the better fit.
Same automatic control, no cable between the tank and the pump - for sites where running one is impractical.
This website use cookies to help you have a superior and more relevant browsing experience on the website. Read more...